process_info_pdms_devices
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| process_info_pdms_devices [2021/07/15 21:39] – [Device Bonding] magnuson | process_info_pdms_devices [2024/09/25 22:26] (current) – kho | ||
|---|---|---|---|
| Line 218: | Line 218: | ||
| **Procedure: | **Procedure: | ||
| - | - Confirm that the oven is set to 80 C. Either oven in the Microfluidics Lab is acceptable. | + | - Confirm that the oven is set to 80 C. Either oven in Elings 3430 is acceptable. |
| - Identify an empty oven tray to use for spill protection. | - Identify an empty oven tray to use for spill protection. | ||
| - Carefully transport degassed elastomer to the ovens. | - Carefully transport degassed elastomer to the ovens. | ||
| Line 422: | Line 422: | ||
| - Remove the metal lid of the sonicator bath. Check that the bath is filled to the operating level (if not, fill to the line with DI). | - Remove the metal lid of the sonicator bath. Check that the bath is filled to the operating level (if not, fill to the line with DI). | ||
| - Place the plastic cutouts across the bath, resting it on the ledges that seat the lid. One cutout has 2 openings, the other has only 1. | - Place the plastic cutouts across the bath, resting it on the ledges that seat the lid. One cutout has 2 openings, the other has only 1. | ||
| - | - Retrieve the appropriate beakers from the drying rack above the sink in the microfluidics lab. - Select the beakers labeled Acetone, IPA, and DI Water. Confirm that each beaker has a plastic tube / zip tie ring around it to act as a cushion. | + | - Retrieve the appropriate beakers from the drying rack above the sink in Elings 3430. - Select the beakers labeled Acetone, IPA, and DI Water. Confirm that each beaker has a plastic tube / zip tie ring around it to act as a cushion. |
| - Fill each beaker with the corresponding chemical using the solvent bottles in the cabinet underneath the fume hood. | - Fill each beaker with the corresponding chemical using the solvent bottles in the cabinet underneath the fume hood. | ||
| - Carefully seat each beaker in one of the cutouts. Confirm that the base of the container rests below the water level. | - Carefully seat each beaker in one of the cutouts. Confirm that the base of the container rests below the water level. | ||
process_info_pdms_devices.1626385154.txt.gz · Last modified: 2021/07/15 21:39 by magnuson