Differences

This shows you the differences between two versions of the page.

--- miicraft_50_sop [2020/08/17 17:29] – [Accident Response] furst
+++ miicraft_50_sop [2023/07/19 21:40] (current) – rylin
@@ Line 11: / Line 11: @@
 In person training is required to use this machine. New users should read the Miicraft manual
 and follow along to the operating checklist (found on the IW GauchoSpace Website).
-Supplemental videos are also provided to follow along to
+Supplemental videos are also provided to follow along to.
 **Training Outline**
 Description of the system:
-  * The system is comprised of the MiiCraft 3D printer, the connected desktop computer with the MiiUtility software, and the IPA bath and cleaning station in Fume Hood #4 a resin tank with a thin teflon bottom is placed over a glass projection window and clamped down to create a flat interface
+  * The system is comprised of the MiiCraft 3D printer, the connected desktop computer with the MiiUtility software, and the IPA bath and cleaning station in Fume Hood #4—a resin tank with a thin teflon bottom is placed over a glass projection window and clamped down to create a flat interface
   * A z-axis travelling build platform is lowered into the resin tank, where a fine layer of resin is cured through the teflon bottom using a DLP projector chip
   * After printing, the entire build plate is removed and placed in the FormWash station, an agitated IPA bath that will clean off excess resin
@@ Line 32: / Line 32: @@
   - At the Printer:
     - Turn on the power if the printer is not already on
-    - Retrieve a clean build plate from fume hood #4, clean off any excess resin with IPA
+    - Retrieve a clean build plate from Fume Hood #4, clean off any excess resin with IPA
-    - Open the printer door and remove the resin tank cover visually inspect the resin. Stir it up gently with a card if any discolored oily streaks are present at the surface
+    - Open the printer door and remove the resin tank cover visually inspect the resin. Stir it up gently with a card if there are any discolored oily streaks are present at the surface
     - Install the clean build plate, make sure it is firmly seated, and press down on the locking lever Close the printer door and move on to the software.
   - At the Computer:
@@ Line 93: / Line 93: @@
 **Accident:** Chemical spill of IPA or toxic resin \\
 **Solution:**
+====References====
+{{ :tools:miicraft50:miicraft125_manual_printerv1.5.pdf |MiiCraft Manual}} \\
+{{ :tools:miicraft50:miicraft_calibration_data.pdf |MiiCraft Calibration Data}} \\
+{{ :tools:miicraft50:resinworks3d_msds.pdf |ResinWorks MSDS}} \\
+{{ :tools:miicraft50:transferring_the_resin_sop.pdf | Transferring Resin SOP}} \\
+{{ :tools:miicraft50:ucsb-iw_miicraft_50_operating_checklist.pdf |Operations Checklist}}