Differences

This shows you the differences between two versions of the page.

--- go_pro [2024/08/16 22:03] – created epace
+++ go_pro [2024/08/19 17:38] (current) – [Detailed Specifications] epace
@@ Line 2: / Line 2: @@
-^                      Go Pro          ^
+^                      Go Pro Black 7       ^
-|                                                                       |
+|                               {{:go_pro.jpg?200|}}                            |
 | **Tool Type:**                  Imaging / measurement                          |
 | **Location:**                   Innovation Workshop                           |
@@ Line 14: / Line 14: @@
 ===== About =====
 This tool is located in 3430 above the 3D printers on the top shelf.
+To use this tool, turn the camera on with the power button on the side. The camera is touch screen. To change the camera mode, swipe left or right. The different modes are video, photo, or timelapse. To see photos/videos that you have taken, swipe up from the bottom of the screen. There are additional settings if you swipe down from the top of the camera.
 ----
 ===== Detailed Specifications =====
+Refer to the manual linked below.
 -----
 ===== Reference Documentation =====
+{{ :go_pro_manual.pdf |}}
 -----