Differences

This shows you the differences between two versions of the page.

--- formcure_uv [2023/01/04 01:47] – bassari
+++ formcure_uv [2024/09/26 19:52] (current) – epace
@@ Line 1: / Line 1: @@
 ====== FormCure UV Curing Station ======
-^                   FormCure UV Curing Station                          ^
+^                   FormCure                         ^
 |            {{ :tools:formcureuv:formcureuv.png?nolink&200 |}}         |
-| **Tool Type:**                  UV Curing Station                       |
+| **Tool Type:**                  Post-processing                       |
-| **Location:**                   Innovations Worship                           |
+| **Location:**                   Elings 3430                          |
-|  **Supervisor**        |  **Tool Lead**  |
-|  Brian Dincau         |  WW Name  |
-|          |  (###) ###-####  |
-|  workshop-manager@cnsi.ucsb.edu	 |  WW Email  |
-| **Description:**                This tool cures parts 3D printed by the Formlabs 3.                           |
+| **Description:**                FormLabs UV curing chamber                           |
 | **Manufacturer:**               FormLabs                       |
+Last updated 1/5/23 Haley
 ----
 ===== About =====
-Some FormLabs Resins used in the Form 2 3D printer can benefit from post process curing. Each resin has a specific hardening curve which can be found within the reference material which will indicate the ideal time and temperature to be set on the FormCure.
+After your FormLabs print has gone through the FormWash, the resin should be cured in the FormCure, a UV curing chamber. Each resin has a specific hardening curve that can be found within the reference material. This will help you indicate the ideal time and temperature to be set on the FormCure.
-----
-===== Detailed Specifications =====
-  * Max cure temp: 80 degrees C
-  * Light: 39W total drawn by 13 405 nm LEDs
 ----
@@ Line 32: / Line 23: @@
 ===== Safety Concerns =====
-  * Allow at least half an hour for IPA to evaporate before placing part in Form Cure
+  * Allow at least half an hour for IPA to evaporate before placing part in FormCure
   * Allow time for the Form Cure to cool off before removing parts
   * Do not operate form cure with lid open
@@ Line 47: / Line 38: @@
 -----
+===== Detailed Specifications =====
+  * Max cure temp: 80 degrees C
+  * Light: 39W total drawn by 13 405 nm LEDs
+----
 ===== Reference Documentation =====
+[[form2sop|Form 2 Training SOP]]
 [[https://support.formlabs.com/s/article/Using-Form-Cure?language=en_US]]
@@ Line 59: / Line 61: @@
-===== Training Documentation =====
-[[form2sop|Form 2 Training SOP]]
-----