Differences

This shows you the differences between two versions of the page.

--- formcure_uv [2020/04/03 22:29] – created martinez
+++ formcure_uv [2024/09/26 19:52] (current) – epace
@@ Line 1: / Line 1: @@
 ====== FormCure UV Curing Station ======
-^                   FormCure UV Curing Station                          ^
+^                   FormCure                         ^
 |            {{ :tools:formcureuv:formcureuv.png?nolink&200 |}}         |
-| **Tool Type:**                  "TEXT HERE"                           |
+| **Tool Type:**                  Post-processing                       |
-| **Location:**                   "TEXT HERE"                           |
+| **Location:**                   Elings 3430                          |
-|  **Supervisor**        |  **Tool Lead**  |
-|  David Bothman         |  "WW Name"  |
-|  (805) 893-4125        |  (###) ###-####  |
-|  bothman@cnsi.ucsb.edu  |  "WW Email"  |
-| **Description:**                "TEXT HERE"                           |
-| **Manufacturer:**               "TEXT HERE"                           |
+| **Description:**                FormLabs UV curing chamber                           |
+| **Manufacturer:**               FormLabs                       |
+Last updated 1/5/23 Haley
 ----
 ===== About =====
-Insert Text Here!
+After your FormLabs print has gone through the FormWash, the resin should be cured in the FormCure, a UV curing chamber. Each resin has a specific hardening curve that can be found within the reference material. This will help you indicate the ideal time and temperature to be set on the FormCure.
 ----
-===== Detailed Specifications =====
+===== Safety Concerns =====
-Insert Text Here!
+  * Allow at least half an hour for IPA to evaporate before placing part in FormCure
+  * Allow time for the Form Cure to cool off before removing parts
+  * Do not operate form cure with lid open
 ----
-===== Safety Concerns =====
+===== Operating Procedures =====
-Insert Text Here!
+  - Any part to be cured needs to be washed in the FormWash with IPA BEFORE being placed in the form cure. Supports can be removed before or after curing process.
+  - Wait 30 minutes after washing to allow all remaining IPA to evaporate
+  - Check the reference material for selected resin to determine ideal time and temperature for curing
+  - Use the dial on the front of the FormCure to set time and temperature
+  - Place part within the FormCure-> press start.
-----
+-----
-===== Operating Procedures =====
+===== Detailed Specifications =====
+  * Max cure temp: 80 degrees C
+  * Light: 39W total drawn by 13 405 nm LEDs
-Insert Text Here!
 ----
 ===== Reference Documentation =====
-Insert Text Here!
+[[form2sop|Form 2 Training SOP]]
+[[https://support.formlabs.com/s/article/Using-Form-Cure?language=en_US]]
+[[https://support.formlabs.com/s/article/Form-Cure-Time-and-Temperature-Settings?language=en_US]]
+[[https://support.formlabs.com/s/article/Form-Cure-Time-and-Temperature-Settings?language=en_US]]
-===== Training Documentation =====
-Insert Text Here!
-----