Differences

This shows you the differences between two versions of the page.

--- electro-technic_treater [2023/01/05 20:35] – [Electro-Technic BD-20AC Corona Treater] haley
+++ electro-technic_treater [2024/09/26 20:04] (current) – epace
@@ Line 4: / Line 4: @@
 ^             Electro-Technic Corona Treater                    ^
 |  {{ :tools:electro-technictreater:electro-technic_treater.jpg?nolink&200 |}}   |
-| **Tool Type:**                  TEXT HERE                          |
+| **Tool Type:**                  Surface treatment                         |
-| **Location:**                   Microfluidics Lab                           |
+| **Location:**                   Elings 3430                           |
-| **Description:**                TEXT HERE                          |
+| **Description:**                High frequency generator used for surface treating of polymers                          |
-| **Manufacturer:**               TEXT HERE                           |
+| **Manufacturer:**               Electro-Technic Products Inc.                           |
 ----
 ===== About =====
+Corona discharge wands use a high frequency electric field to ionize the surrounding air over a very short range. In principle, their operation is similar to a tesla coil, which accumulates charge until a high enough voltage is reached to produce a spark. Each spark produces a small amount of plasma (as indicated by the light produced) which creates active ions that increase the surface energy of polymers.
-Insert Text Here!
+The primary reason to increase the surface energy of a polymer is to make is stickier. For instance, many paints, inks, and functional biological & chemical reagents will adhere to corona-treated polymers much better than untreated polymers. Additionally, some polymers, such as PDMS, will stick to each other after corona treatment.
 ----
-===== Detailed Specifications =====
+===== Safety Concerns =====
+**High Voltage** - Keep the electrode tip away from your body. Care should be taken to prevent the electrode from arcing to any worn metal items, such as jewelry. Since this is a very low current device, a spark will cause discomfort but not harm. However, the sudden shock could be alarming and catalyze other accidents. \\
-Insert Text Here!
+**High-Temperature Plasma** - Do not operate this device near any flammable liquids or gases. The electric spark may ignite them.
-----
+**Ozone Generator** - Ozone, produced at the electrode tip, has a somewhat pungent odor but should dissipate harmlessly in a ventilated area. Do not use in confined spaces with poor ventilation.
-===== Safety Concerns =====
+**High Frequency (RF)** - If you wear a pacemaker or other medical electronic device, consult your physician before use.
-Insert Text Here!
 ----
 ===== Operating Procedures =====
+) Plug the device in. \\
+) Bring the electrode tip near a large metal object or a ground connection. \\
+) Power on the device with voltage knob set to minimum. \\
+) Adjust the voltage knob to obtain the desired spark length. (Test the spark length against your metal object or ground connection. Start with 1/8" to 1/4" if this is a new recipe.) \\
+) Treat your sample with the discharge wand by bringing the electrode close to the surface and sweeping it with the spark. Treatment distance and time will depend on your substrate and desired effect. \\
+) When finished, set the voltage to minimum, power off the device, then unplug it.
-Insert Text Here!
+----
+===== Detailed Specifications =====
+See attached reference documentation for full specification.\\
+\\
+Output voltage - 10 to 48 kV \\
+Frequency - 4 to 5 MHz \\
+Operation - Continuous \\
 ----
 ===== Reference Documentation =====
@@ Line 42: / Line 60: @@
 ------
-===== Training Documentation =====
-Insert Text Here!
-----