Differences

This shows you the differences between two versions of the page.

--- einscan-sp [2023/01/06 01:10] – [Operating Procedures] haley
+++ einscan-sp [2024/09/26 19:49] (current) – epace
@@ Line 4: / Line 4: @@
 |              {{ :tools:einscan-sp:einscan-sp.jpg?nolink&200 |}}       |
 | **Tool Type:**                  3D Scanner                          |
-| **Location:**                   Innovation Workshop                          |
+| **Location:**                   Elings 3430                          |
@@ Line 10: / Line 10: @@
 | **Manufacturer:**               EinScan                           |
+Last updated 1/5/23 Haley
 ----
 ===== About =====
-The SHINNG3D EinScan-SP 3D Scanner is located under the blackout curtains within Fume Hood #1 in the Innovation Workshop. A part can be placed on the central turn table, which will rotate as the scanner projects light onto the object being scanned. Transparent, reflective, or very dark surfaces are inherently difficult to scan, but coating the surface with powder may aid the quality of the scan. Calibration of the 3D scanner can aid in scan accuracy and should be done before scanning the first object.
+The SHINNG3D EinScan-SP 3D Scanner is located in 3430. Please ask staff to help you set it up if you wish to use this tool. A part can be placed on the central turn table, which will rotate as the scanner projects light onto the object being scanned. Transparent, reflective, or very dark surfaces are inherently difficult to scan, but coating the surface with powder may aid the quality of the scan. Calibration of the 3D scanner can aid in scan accuracy and should be done before scanning the first object.
 ----
@@ Line 28: / Line 29: @@
 ===== Operating Procedures =====
+  - Follow the instructions to calibrate the scanner
   - Create a new project and designate file location
   - Select desired texture mode (texture uses color data whereas non texture takes less time)