trotec_speedy
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
trotec_speedy [2023/05/31 20:56] – [About] haley | trotec_speedy [2023/07/18 20:20] – rylin | ||
---|---|---|---|
Line 15: | Line 15: | ||
===== About ===== | ===== About ===== | ||
- | 30-60W CO2 laser used to cut and engrave various materials. | + | The Trotec Laser Cutter uses a 30-60W CO2 laser to cut and engrave various materials. |
---- | ---- | ||
Line 24: | Line 24: | ||
* Always wear safety glasses when using the machine. | * Always wear safety glasses when using the machine. | ||
* Always work with the machine cover closed. | * Always work with the machine cover closed. | ||
- | * NEVER leave the laser machine alone when running a job. If you do need to leave, | + | * NEVER leave the laser machine alone when running a job. If you do need to leave, |
* The machine door must be left open while you are away. | * The machine door must be left open while you are away. | ||
* Do not store any flammable materials in the inside of the device or in the immediate vicinity of the device. | * Do not store any flammable materials in the inside of the device or in the immediate vicinity of the device. |
trotec_speedy.txt · Last modified: 2023/10/10 18:50 by bdincau