trimsaw2sop
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Last revisionBoth sides next revision | ||
trimsaw2sop [2020/11/03 17:45] – furst | trimsaw2sop [2020/11/03 17:45] – furst | ||
---|---|---|---|
Line 82: | Line 82: | ||
* Replace the table | * Replace the table | ||
- | ====Blade Selection | + | ====Blade Selection==== |
* CBN Bond blades are used for cutting ferrous metals. Metal bond blades <1,000 RPM, Resin bond blades >1000 RPM | * CBN Bond blades are used for cutting ferrous metals. Metal bond blades <1,000 RPM, Resin bond blades >1000 RPM | ||
* Diamond Metal Bond blades: high concentration blades for general use at high or low speeds, low concentration blades for ceramics, Silicon, glass. Cut at low speed ,1,000 RPM | * Diamond Metal Bond blades: high concentration blades for general use at high or low speeds, low concentration blades for ceramics, Silicon, glass. Cut at low speed ,1,000 RPM |
trimsaw2sop.txt · Last modified: 2020/11/03 17:46 by furst