User Tools

Site Tools


trimsaw2sop

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revisionBoth sides next revision
trimsaw2sop [2020/11/02 23:12] – [Overview:] davetrimsaw2sop [2020/11/02 23:14] – [Job Setup] dave
Line 79: Line 79:
   * Lightly LUBRICATE the threads on the end of the blade arbor with silicone grease to prevent thread galling. Silicone grease is on the bottom shelf of the chemical storage rack between the two fume hoods.     * Lightly LUBRICATE the threads on the end of the blade arbor with silicone grease to prevent thread galling. Silicone grease is on the bottom shelf of the chemical storage rack between the two fume hoods.  
   * Tighten the blade retaining nut HAND TIGHT (no need to go crazy on this one down)    * Tighten the blade retaining nut HAND TIGHT (no need to go crazy on this one down) 
-  * Insure the coolant level is in contact with the bottom of the blade and filled to the fill line+  * Check to make sure that the blade is submerged in the coolant by about 0.25 inches. The required coolant level will depend on the blade diameter.
   * Replace the table   * Replace the table
  
trimsaw2sop.txt · Last modified: 2020/11/03 17:46 by furst