syringe_pumps_ha
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
syringe_pumps_ha [2023/01/30 21:10] – bdincau | syringe_pumps_ha [2023/01/30 21:30] – bdincau | ||
---|---|---|---|
Line 28: | Line 28: | ||
===== Detailed Specifications ===== | ===== Detailed Specifications ===== | ||
- | Insert Text Here! | + | See product manual for extended specifications. |
+ | |||
+ | Maximum force: 50 lb (200 N) \\ | ||
+ | Minimum syringe size & minimum flow rate: 0.5 uL @ 0.0001 uL/hr \\ | ||
+ | Maximum syringe size & maximum flow rate: 140 mL @ 220 mL/min \\ | ||
---- | ---- | ||
Line 34: | Line 38: | ||
===== Safety Concerns ===== | ===== Safety Concerns ===== | ||
- | Insert Text Here! | + | **Pinching Hazard** - Be careful when loading syringes to avoid pinching oneself with the syringe holders. \\ |
+ | **High Pressure Hazard - Always wear goggles when operating syringe pumps.** If too much pressure accumulates in your system, often due to clogging, your tubing or attached fluidic devices can rupture. This can create a jet of fluid which presents a physical hazard to those nearby. \\ | ||
---- | ---- | ||
Line 40: | Line 45: | ||
===== Operating Procedures ===== | ===== Operating Procedures ===== | ||
- | Insert Text Here! | + | Please reference the attach operation manual for detailed operating instructions. |
+ | |||
+ | **General Operation** \\ | ||
+ | 1) Select your syringe size using either the measured internal diameter of the syringe (recommended) or the built-in syringe lookup table. \\ | ||
+ | 2) Install and fill your syringe(s). \\ | ||
+ | 3) Select the desired flow rate. \\ | ||
+ | 4) Select the desired target volume (optional). If you set a target volume and operate in volume mode, pumping will automatically cease when the target volume has been reached. Otherwise, the pump will not stop until manually turned off. \\ | ||
+ | 5) When finished, remove syringes, power off the pump, and clean the pump if contaminated by any fluid during your experiment. | ||
---- | ---- | ||
Line 48: | Line 60: | ||
{{ : | {{ : | ||
- | ===== Training Documentation ===== | ||
- | |||
- | Insert Text Here! | ||
- | ---- | ||
syringe_pumps_ha.txt · Last modified: 2023/01/30 21:30 by bdincau