start
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
start [2023/11/16 18:34] – [Lab Announcements] bdincau | start [2024/03/04 21:15] – [Lab Announcements] bdincau | ||
---|---|---|---|
Line 10: | Line 10: | ||
===== Lab Announcements ===== | ===== Lab Announcements ===== | ||
- | 11/16/23 \\ | + | 03/04/24 \\ |
- | The labs will be **unstaffed from Wed 11/22 until Mon 11/27** due to the Thanksgiving holiday. Please consider joining | + | **The Innovation Workshop and Microfluidics Lab have been merged into one FBS facility.** Please ensure that you are working inside |
- | If you use our facilities during the holiday, **please do not let other into the building or labs.** Only those with swipe access should be entering our facilities outside of business hours. We had a small theft in Elings over Veteran' | + | {{ : |
- | 10/20/23 \\ | + | 02/26/24 \\ |
- | **We are ready to offer training on our [[wazer_waterjet | waterjet | + | The **waterjet |
- | In our experience so far, it's a good tool for cutting materials which are 1/8" (3mm) or less, especially thin materials like sheet metal and carbon fiber. Sign up for training using the Training Request Form linked below. | + | |
+ | 02/23/24 \\ | ||
+ | |||
+ | The **waterjet is currently down.** The pump pressure is low and the pump is vibrating in an unhealthy way. We are working to restore | ||
10/06/23 \\ | 10/06/23 \\ | ||
Line 31: | Line 34: | ||
**We have redesigned our silanization chamber.** The new chamber features polymer valves and fittings which should not corrode like the stainless steel fittings used in the previous chamber. The silane agent is also stored in a sealed glass container now, so we can easily see when it is running low. Please take a moment to [[vapor_silanation_rig_sop_new | review the new SOP]] before using the tool. Report any issue to the lab manager, and note them in the log book. | **We have redesigned our silanization chamber.** The new chamber features polymer valves and fittings which should not corrode like the stainless steel fittings used in the previous chamber. The silane agent is also stored in a sealed glass container now, so we can easily see when it is running low. Please take a moment to [[vapor_silanation_rig_sop_new | review the new SOP]] before using the tool. Report any issue to the lab manager, and note them in the log book. | ||
- | |||
- | 09/11/23 \\ | ||
- | |||
- | The Trotec **laser cutter has been restored,** and may now be used again. After a thorough cleaning, we replaced the honeycomb bed and airjet lines. We also performed a few routine test cuts to make sure that the lens and positional accuracy were not affected. | ||
- | |||
- | |||
- | |||
- | 06/01/23 \\ | ||
- | |||
- | Have you ever wondered **which resin printer is best for your application? | ||
start.txt · Last modified: 2024/05/30 17:59 by bdincau