start
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
start [2023/10/20 17:01] – [Lab Announcements] bdincau | start [2024/03/04 21:15] – [Lab Announcements] bdincau | ||
---|---|---|---|
Line 10: | Line 10: | ||
===== Lab Announcements ===== | ===== Lab Announcements ===== | ||
+ | 03/04/24 \\ | ||
- | 10/20/23 \\ | + | **The Innovation Workshop and Microfluidics Lab have been merged into one FBS facility.** Please ensure that you are working inside the new facility, appropriately named " |
- | **We are ready to offer training on our [[wazer_waterjet | + | {{ : |
- | In our experience so far, it' | + | 02/26/24 \\ |
+ | |||
+ | The **waterjet is back**. After disconnecting, draining, then reconnecting the pump, the pressure came back up and stabilized. If you use the waterjet in the next few weeks, please pay attention to the flow rate. If it drops dramatically, | ||
+ | |||
+ | |||
+ | 02/23/24 \\ | ||
+ | |||
+ | The **waterjet is currently down.** The pump pressure is low and the pump is vibrating in an unhealthy way. We are working to restore the tool asap. | ||
10/06/23 \\ | 10/06/23 \\ | ||
Line 26: | Line 34: | ||
**We have redesigned our silanization chamber.** The new chamber features polymer valves and fittings which should not corrode like the stainless steel fittings used in the previous chamber. The silane agent is also stored in a sealed glass container now, so we can easily see when it is running low. Please take a moment to [[vapor_silanation_rig_sop_new | review the new SOP]] before using the tool. Report any issue to the lab manager, and note them in the log book. | **We have redesigned our silanization chamber.** The new chamber features polymer valves and fittings which should not corrode like the stainless steel fittings used in the previous chamber. The silane agent is also stored in a sealed glass container now, so we can easily see when it is running low. Please take a moment to [[vapor_silanation_rig_sop_new | review the new SOP]] before using the tool. Report any issue to the lab manager, and note them in the log book. | ||
- | |||
- | 09/11/23 \\ | ||
- | |||
- | The Trotec **laser cutter has been restored,** and may now be used again. After a thorough cleaning, we replaced the honeycomb bed and airjet lines. We also performed a few routine test cuts to make sure that the lens and positional accuracy were not affected. | ||
- | |||
- | |||
- | |||
- | 06/01/23 \\ | ||
- | |||
- | Have you ever wondered **which resin printer is best for your application? | ||
start.txt · Last modified: 2024/06/06 17:44 by bdincau