sherline_training_sop
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
| sherline_training_sop [2022/10/03 20:47] – [CNC Setup] furst | sherline_training_sop [2022/10/03 20:48] – furst | ||
|---|---|---|---|
| Line 90: | Line 90: | ||
| ====CNC Setup==== | ====CNC Setup==== | ||
| - | - Turn on the Flashcut CNC box | ||
| {{: | {{: | ||
| + | - Turn on the Flashcut CNC box | ||
| - On the Sherline computer, start FlashCut CNC (thunderbolt icon) | - On the Sherline computer, start FlashCut CNC (thunderbolt icon) | ||
| - Within FlashCut, select the home tab, followed by seek home. This will move all axis to their zero position. | - Within FlashCut, select the home tab, followed by seek home. This will move all axis to their zero position. | ||
| Line 168: | Line 168: | ||
| * Used drill bits are free | * Used drill bits are free | ||
| * If a new dill bit is selected, ensure it is logged within FBS so recharge can be applied {{: | * If a new dill bit is selected, ensure it is logged within FBS so recharge can be applied {{: | ||
| + | |||
| ----- | ----- | ||
sherline_training_sop.txt · Last modified: 2022/10/05 22:18 by furst