miter_saw_sop
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
miter_saw_sop [2020/12/04 19:05] – furst | miter_saw_sop [2020/12/04 19:10] – [Safety Concern] furst | ||
---|---|---|---|
Line 102: | Line 102: | ||
- Position the workpiece pressed firmly against the fence making sure it is supported on both ends if overhanging the saw body | - Position the workpiece pressed firmly against the fence making sure it is supported on both ends if overhanging the saw body | ||
- The fence can be adjusted slightly if necessary | - The fence can be adjusted slightly if necessary | ||
+ | - Lining up the cut can be done with the laser guide (button on top of articulating head) | ||
- Using external C-clamps secure the workpiece against the fence and resting on the saw body | - Using external C-clamps secure the workpiece against the fence and resting on the saw body | ||
- Clamps should fully secure the workpiece before and after the cut. Be aware on how the center of gravity of the workpiece will change as it is cut if dealing with a long workpiece. | - Clamps should fully secure the workpiece before and after the cut. Be aware on how the center of gravity of the workpiece will change as it is cut if dealing with a long workpiece. | ||
Line 138: | Line 139: | ||
====Safety Concern==== | ====Safety Concern==== | ||
* Safety glasses or a face shield must be warn at all time when operating the saw | * Safety glasses or a face shield must be warn at all time when operating the saw | ||
+ | * Hearing protection is recommended while operating the saw and for users of adjoining lab | ||
* Only cut one workpiece at a time | * Only cut one workpiece at a time | ||
* Be sure workpiece is properly secured | * Be sure workpiece is properly secured |
miter_saw_sop.txt · Last modified: 2020/12/21 01:19 by furst