User Tools

Site Tools


f270_sop

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
Last revisionBoth sides next revision
f270_sop [2020/08/27 16:45] – [Maintenance Schedule (see user maintenance page 80):] furstf270_sop [2022/07/01 16:48] – [Part Removal and Cleaning] haley
Line 94: Line 94:
   * If support was used, submerge print in warm water for several hours to dissolve PVA filament. (prints can warp if submerged in water for over 24 hours) \\   * If support was used, submerge print in warm water for several hours to dissolve PVA filament. (prints can warp if submerged in water for over 24 hours) \\
 **F270** **F270**
-  * Don gloves, face shield, and lab coat +  * Remove the build tray and flex it to break the bond between the material and the tray. 
-  * Carefully, slowly and without splashing cleaning solution open the support removal tank lidremove and open the tank+  * Separate your part from the build tray with a spatula and scrape off any debris so they tray can be reused.  
 +  * Put on the appropriate PPE: don gloves, face shield, and lab coat. 
 +  * Carefully, slowlyand without splashing cleaning solutionopen the support removal tank lid and remove and open the tank.
   * Place large parts directly in the tank, small parts may be put in the SS box and placed into the main basket.   * Place large parts directly in the tank, small parts may be put in the SS box and placed into the main basket.
-  * Carefully, slowly and without splashing lower the basket back into the tank and close the lid. +  * Carefully, slowlyand without splashing lower the basket back into the tank and close the lid. 
-  * Set timer for 6 hours setting the temperature to 80 degrees C.   +  * Set timer for 6 hours using the "set" button. 
-  * After cleaning time has elapsed follow the instructions above for opening and removing parts. +  * Select the temperature to be 85 degrees C and push the power button to warm the tank
-  * Rinse part in warm water+  * After cleaning time has elapsedfollow the instructions above for opening and removing parts. 
 +  * Rinse part in warm water.
  
 ---- ----
f270_sop.txt · Last modified: 2022/07/01 17:13 by haley