3d_print_water_jet_cleaning_station
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
3d_print_water_jet_cleaning_station [2023/01/06 00:34] – [Operating Procedures] haley | 3d_print_water_jet_cleaning_station [2023/01/06 00:35] – [Operating Procedures] haley | ||
---|---|---|---|
Line 35: | Line 35: | ||
- After part has been cleaned, **ensure the water is switched off** as leaks have occurred within Elings Hall before and will damage equipment | - After part has been cleaned, **ensure the water is switched off** as leaks have occurred within Elings Hall before and will damage equipment | ||
- To achieve optimal mechanical properties, or if part is to be used as a mold for casting, part should be baked at 60 degrees C for a minimum of 4 hours | - To achieve optimal mechanical properties, or if part is to be used as a mold for casting, part should be baked at 60 degrees C for a minimum of 4 hours | ||
+ | |||
+ | ---- | ||
===== Detailed Specifications ===== | ===== Detailed Specifications ===== | ||
* Water consumption: | * Water consumption: |
3d_print_water_jet_cleaning_station.txt · Last modified: 2023/07/12 17:05 by rylin