=====CNSI Innovation Workshop Grizzly H8192 Combination Belt/Disk Sander User Outline=====
====Location====
The combination belt/disk sander is located in 2448 Elings Hall on the bench next to Fume Hood #3.
====Safety====
  * Follow the basic machine tool safety protocol: safety glasses, long pants, closed toe shoes, no loose clothing, jewelry or hair that may get caught in the moving machine 
  * Workpiece must be supported on the machine table so that it is not pulled out of your hand.
  * Only sand on the downward-moving half of the disk sander where friction pushes the workpiece into the table.
  * Connect a vacuum to the sander if you will be generating a lot of dust. 
  * Friction may heat workpiece to high temperatures - be careful not to touch hot surfaces.
  * Keep body parts clear of sandpaper. Use a tool to hold small parts.
  * Don’t wear bracelets, dangling articles of clothing, gloves or long sleeves while using the sander.
====Training====
Training is required before using the sander.
===Training Outline===
  - Explain parts of the tool
  - Review safety concerns
  - Demonstrate safe use of the tool
  - Show location of supplies
  - Demonstrate how to change belts/disks
  - Cleanup
====Overview====
The tool is a benchtop sander with a 1" wide x 42" long sanding belt, and an 8" disk sander driven by a common motor. Each of these sanders has a separate vacuum port connection.
====User Guide====
**Sequence of operation:**
  - Wear proper PPE (safety glasses), face shield if needed
  - Turn on sander. 
  - With workpiece resting on the table bring work into contact with the grinding wheel slowly and smoothly.
  - Move the work back and forth across the face of the sanding belt/disk to wear the abrasive evenly.
  - Use gentle pressure. Replace worn pads, or use a coarser sandpaper if more aggressive sanding is required. 
  - Turn off the sander.
  - Use the shop vacuum to clean dust from work area.
====Frequently Asked Questions====
  * What materials can I sand?
    * Aluminum
    * Wood
    * Plastics (be careful not to melt the plastic.
    * Very light sanding of steel is possible.
====Accident Response====
  * In the event of injury, contact lab staff and emergency services if necessary (?)
====Maintenance====
  * Change sandpaper as necessary
  * Clean dust off of machine and work area
====Supplies (In drawer labeled “Grinder Accessories”)====
  * 1" x 42" sanding belts
  * 8" adhesive-backed sanding disks
====Notes====
  * Please refer to the manual for instructions on changing belts and sanding disks.